Crystal Industrial’s Non-retractable injection quills from India are used for lesser diameter primary applications where a close down is possible

Uncategorized, ,
Crystal Industrial’s Standard Injection Quill – 150 psi ranked 1500 psi evaluated (Metallic)

Crystal Industrial’s Non-retractable injection quills from India have two male pipe threads for establishment. Referencing the cut sheet; the lower male pipe thread is the primary fitting while the upper male thread attaches with the pump release line through a coupling or tube fitting.

These units are very good for lesser diameter primary applications where a close down is possible, hence enabling service of the quill to occur.

Alternatives and materials of development not recorded can be made accessible upon demand but may need longer lead times.

Crystal Industrial’s Injection Quill with Spring Loaded Ball Check Valve
  • An incorporated spring loaded ball check valve rules out reverse flow at the insertion point.
  • These units are a good fit for lesser diameter fundamental applications where a close down is possible, subsequently permitting service of the quill to occur.
Crystal Industrial’s Injection Quill with Spring Loaded Ball Check Valve and Quick Release Coupling

A built-in spring loaded ball check valve rules out reverse flow at the injection point.

The quick discharge coupling offers a technique to detach the pump release line without risking presentation to the chemical while maintaining the injection quill. Utilized when adaptable tubing is the preferred technique for establishment from the pump to the insertion point.

Establishment Information for Crystal Industrial’s Non-Retractable Injection Quills from India
Cautions
  • Injection quills are intended to convey a chemical solution feed to the inside of a pressurized water/process main. The below mentioned cautions must be taken to assure appropriate and safe establishment:
  • Get familiar with the parts of the injector as recorded beneath.
  • Confirm that the injector being placed is congenial with the expected chemical feed.
  • Make a point to utilize the right hex when utilizing a wrench to set up.
Establishment Instructions
  • Precaution: Take care not to over fix PVC housings. Harm caused by over fixing voids guarantee.
  • Apply Teflon thread tape or appropriate sealant to the Primary Connection Thread of the injector.
  • Thread the quill into the Primary fitting utilizing the lower establishment Hex in the service tap.
  • Attach chemical feed line to inside thread.
Separating the quick release coupling
  • Draw back on the external ring of the Female Half of the Quick Release Coupler.
  • While withdrawing on the external ring lift the Female Half up off the Male Half Nipple.
Attaching the quick release coupling

Draw back on the external ring of the Female Half of the Quick Release Coupler.

While withdrawing on the external ring push the Female Half down onto the Male Half Nipple. Once situated discharge the external ring to fasten the coupler into place.

Parts
  • Inlet Thread.
  • Try not to utilize wrench on this hex.
  • Incorporated Spring Loaded Ball Check Valve.
  • Establishment Hex, use to fasten amid installation.
  • Primary Connection Thread.
  • Solution Tube.
  • External Ring.
  • Male Half Nipple.
Recommended maintenance
  • Scaling and obstruction can happen contingent upon the chemistry of the utilization and will differ.
  • The Solution Tube and Check Valve interiors must be investigated routinely to assure that it is preventive operation.
Crystal Industrial’s Injection Check Valve from India

Injection check valves can be inserted to any chemical injector or diffuser. The insertion of a check valve will rule out the reverse flow into a chemical feed system. Spring loaded ball check valves are accessible relying upon the size.